Bosch Compress bH fault code
Bosch Compress heat pumps
What the Bosch Compress bH fault code means, from the manufacturer's own service literature, and the UK models it applies to.
What it means
PED board error
Source: Bosch Compress 2000 AWF Installation Manual 6721859133, §12.2 (pp.156-159, render-verified)
Can it be reset?
Power off, wait 5 minutes, power on — check.
Source: Bosch Compress 2000 AWF Installation Manual 6721859133, §12.2 (pp.156-159, render-verified)
UK models this code applies to
Tap yours to open bH on that machine.
Outdoor units37
bH on these comes from each model's own manual, which may not match the meaning above — tap yours to read it.
Now the harder half: proving what caused it
bH names a symptom, not a root cause. In the app, the same code opens a guided investigation: what to measure first, the expected values for your exact model, and an honest verdict — including “nothing in this machine is broken” when that's what the readings say.
Chase bH on your machine →Free, no sign-up. We don't hold a chart for this code yet — pick the model for its manual section.
Or watch one get chased — free demo →Related codes
- A11-6004No communication with solar module
- A31…A34-3021…3024Heating circuit 1…4 flow temperature sensor faulty: standby mode…
- A51-6021Solar collector temperature sensor defective
- A51-6022Cylinder 1 bottom temperature sensor faulty: heating standby mode…
- A61…A64-1081…1084Two master control units in the system (A61/1081 = heating circuit 1…
- C0Multiple units configured as master in the master–slave network
- E0Flow switch error (E8 displayed 3 times; to be seen together with E8)
- E1Phase sequence error (three-phase units only)
- E2Communication error between user interface and main hydraulic module…
- E3Backup heater's heat exchanger outlet T1 temperature sensor error